Command: Fault Controller (8)

See the Commands Overview topic for basic command information and how to issue commands from PLCs, HMIs, etc.

Command Parameters

None.

Description

This command stops all motion on the controller. It can be used as an emergency stop. To issue this command from RMCTools, click the Fault Controller button on the toolbar.

This command does the following:

• Puts the RMC in PROGRAM mode
  This stops all Tasks and the Program Triggers. In order to start Tasks and the Program Triggers again, you must put the RMC into RUN mode.

• Halts all axes
  Performs a Direct Output Halt (3) on each axis.

Why bother?

If you want to shut down the RMC because a major problem occurred, use this command, because you can be sure it will stop all motion on all axes, along with all user programs, and the Program Triggers. If the RMC is in RUN mode and you use a regular Halt instead of this command, the Program Triggers can still start a User Program, which may start motion again.

See Also

List of Commands | Commands Overview