Command: Start Plot (100)

Supported Axes:	All
Firmware Requirement:	1.00 or newer

See the Commands Overview topic for basic command information and how to issue commands from PLCs, HMIs, etc.

Command Parameters

#	Parameter Description	Range
1	Plot Number	any valid plot number

Description

This command starts a one-time plot. It erases the plot buffer and starts capturing a plot until the buffer is full. At that point, it stops capturing and waits until the plot is reset. Compare this with the Stop Plot (101) and Trigger Plot (102) commands.

To find out more about plotting, see the Using Plots topic.